I jotted down these notes a few years back to refer back to later. The trouble I’ve found with all HT radios is you work through the manual to setup a couple of local repeaters and then months (years!) go by and you can’t remember how you did it last time 🙂
Here’s my notes for setting up memories in your FT60:
To toggle freq VFO/memory mode:
- bottom left button: V/M
To store current settings to a memory:
Set the current frequency, and for repeaters the offset, PL tone etc and then store all the currently selected settings to a memory:
- hold bottom right FW
- flashing mem is an empty slot
- press bottom right (FW) again, stores in slot
- switch to memory mode (toggle v/m button)
- FW 0 selects menus
- select 28 nm write, press FW to select
- press FW again to select 1st char, rotate dial to select, up arrow to move to next char
- if you get to last char it stores automatically, otherwise for less than max chars press ptr to enter to memory
To delete a memory:
- go to memory mode, select memory
- hold FW
- select memory with knob
- press hm/rv – deletes mem
Toggle memory freq display
In memory mode, press Band – toggles to freq & tune mode
Press again to toggle back to memories