Using curl by default will return the response of a request as-is. If the response is a redirect, you can tell curl to follow the redirect with the -L option, e.g.
curl -L http://some.site
To use curl to download a file, use the -O option.
Looking up ip address in a CentOS 7 minimal install
In a minimal CentOS 7 install, there’s no ifconfig to check your network settings. Instead use
ip addr
More info here.
Error starting Openshift Origin on CentOS 7: systemd cgroup driver vs cgroupfs driver
Following the instructions to install the Openshift Origin binary from here, on first attempt to start it up I got this error:
failed to run Kubelet: failed to create kubelet:
misconfiguration: kubelet cgroup driver: "systemd" is different from docker cgroup driver: "cgroupfs"
Per instructions in this issue ticket, to verify which cgroup drivers docker is using I used:
$ sudo docker info |grep -i cgroup Cgroup Driver: cgroupfs
Unfortunately the steps to check the cgroup driver for kubernetes don’t match with my install because I’m guessing the single binary Openshift Origin has it packaged all in one, so there is no corresponding systemd config for it.
This article suggested to configure the cgroups driver for Docker so it matches kubernetes, but it looks like the yum install for docker-ce doesn’t configure systemd for it either.
Ok, to the docs. Per the Docker docs for configuring systemd here, it suggests to pull to preconfigured files from a git repo and place them in /etc/systemd/system
Now I have the systemd files for Docker in place, this articles says to add this arg to the end of the ExecStart line in docker.service:
--exec-opt native.cgroupdriver=systemdNow reload my config and restart the docker service:
sudo systemctl daemon-reload sudo systemctl restart docker
and let’s check again what cgroups driver we’re using with:
$ sudo docker info |grep -i cgroup Cgroup Driver: systemd
… and now we’ve switched to systemd.
Ok, starting up Openshift again, this issue is resolved, there’s a lot of log output as the server starts up. After opening up the firewall ports for 8443, my Openshift Console is now up!
Mount exFat filesystem on Debian
ExFat file systems are not supported out of the box on Debian, but support is provided by installing the exfat-utils package:
# apt-get install exfat-utils Reading package lists... Done Building dependency tree Reading state information... Done The following additional packages will be installed: exfat-fuse The following NEW packages will be installed: exfat-fuse exfat-utils 0 upgraded, 2 newly installed, 0 to remove and 28 not upgraded. Need to get 73.0 kB of archives. After this operation, 295 kB of additional disk space will be used. Do you want to continue? [Y/n] y
fdisk -l shows my usb disk as:
Disk /dev/sdc: 186.3 GiB, 200049647616 bytes, 390721968 sectors Units: sectors of 1 * 512 = 512 bytes Sector size (logical/physical): 512 bytes / 512 bytes I/O size (minimum/optimal): 512 bytes / 512 bytes Disklabel type: gpt Disk identifier: ... Device Start End Sectors Size Type /dev/sdc1 40 409639 409600 200M EFI System /dev/sdc2 411648 390721535 390309888 186.1G Microsoft basic data
So to mount sdc2:
mkdir /media/usbdisk (or whatever mountpoint you prefer)
mount -t exfat /dev/sdc2 /media/usbdisk
Done!